|
Greek Recipes
Home-made Feta Cheese
"Tiri Feta Spitisia "
| |
This is the
recipe for home-made Feta cheese as it's made here in our
villages. It isn't a difficult recipe to follow - actually
it's rather easy, but you will need to master the quantities
of salt and 'Pitia' that will give you the consistency and
saltiness that you prefer. |
Ingredients:
2-3 liters fresh goats' milk (see Susie's Note)
1/2 to 1 tbsp. Pitia (see Susie's Note)
1/2 cup warm water
1/2 to 1 tbsp. salt
Brine / Salamoura - Almi:
water
coarse salt (fine will work too)
1 raw egg, washed thoroughly
Extra Supplies:
cheese cloth or fine tulle/netting
fine weaved basket or strainer
clean and sterilized wide mouth jar or container
a dish that will fit inside the jar
a heavy rock that will fit into the jar
Begin by making sure that all your
utensils, pots and supplies are very clean. Put the milk into a pot
over medium heat. Heat it to a low boil, but keep careful that it
doesn't scorch. Cook it for about 5 minutes then set it aside to
cool down until 'warm to the touch'. Dilute the Pitia in the water
and stir it into the warm milk. Stir in the salt and cover the pot
with a clean, cloth towel and set it aside to thicken and curdle in
a warm place. This can take anywhere from 6 to 12 hours.
Pour the thickened milk into a basket or strainer that has been
lined with cheese cloth or fine tulle/netting. Cover the basket
with another piece of net to keep the insects off and hang it over a
sink, or outside so it can drain thoroughly. Check on the draining
cheese. If it seems that the chunks of curd are too big, you can
slice through them with a knife to break them up so more of the
water will drain out. It takes about a full day for the cheese to
drain to 'Feta' consistency, but if you prefer a harder, dryer
cheese, you can let it drain longer. You can also weight down the
draining cheese with a dish and a heavy rock placed over it to aid
in squeezing out more water and will also give you a thicker cheese.
Make the Brine: You will need enough
brine to cover the cheese completely so put an adequate amount of
water into a pot and bring it to a boil. Boil it for 5 minutes,
then remove it from the heat. Add some salt to the water. You will
be using the egg as a gauge for the salinity of your brine. Float
the egg in the brine. Some of the shell should float above water
level, if not, remove the egg and add more salt to the brine. Put
the egg back in to test it again. You want 1-2cm of shell to be
exposed at the water level. The more shell that floats, the saltier
the brine. Keep floating / adding salt until you get the salinity
that you want. Cover the brine and set it aside to cool down
completely.
Invert the basket with the drained
cheese onto a clean work surface and remove the cheese cloth. Cut
the cheese into large blocks and put them into a clean and sterile
container. Pour the cooled brine over the cheese. Keep in mind
that Feta has to be completely submerged in the brine or else it
will go bad. Use an inverted plate with a heavy rock placed on it
to keep the Feta under the brine level.
Susie's Note: Fresh cow's or
sheep's milk can be substituted for the cheese but it will give you
a different flavor and consistency. Pitia is a lactose starter that
is used in cheese making to get the milk to separate into whey
(liquid) and curd (solids). Cultured Buttermilk or some other
lactic culture (such as milk that is in the process of turning sour)
can be substituted (although you'll need a larger quantity - perhaps
1/2 cup to 2 liters of milk) or you can use commercial coagulants
that are available
|Greek
Recipes|
Appetizers, Salads| Soups,Stew|Vegetarian|Greek Bread|Preserv Pickling |
|Sauces, Marinades & Dressings|Beverages & Bottling |
Meat|
Poultry
|Sea
Food|
Desserts|
|